remove 32M spi patch for mtk762x

target/linux/ramips/base-files/etc/board.d/01_leds

@@ -150,6 +150,7 @@ gl-mt750)
 	;;
 gl-mt300n-v2)
 	set_wifi_led "$boardname:red:wlan"
+	ucidef_set_led_switch "wan" "wan" "$boardname:green:wan" "switch0" "0x1"
 	;;
 hc5661|\
 hc5661a)

target/linux/ramips/dts/GL-MT300N-V2.dts

@@ -35,7 +35,7 @@
 		};
 
 		wan {
-			label = "gl-mt300n-v2:blue:wan";
+			label = "gl-mt300n-v2:green:wan";
 			gpios = <&gpio1 11 GPIO_ACTIVE_LOW>;
 		};
 

target/linux/ramips/patches-4.14/999-fix-m25p-shutdown.patch

@@ -1,34 +0,0 @@
-diff --git a/drivers/mtd/devices/m25p80.c b/drivers/mtd/devices/m25p80.c
-index 24e1ea3..b1ff69a 100644
---- a/drivers/mtd/devices/m25p80.c
-+++ b/drivers/mtd/devices/m25p80.c
-@@ -313,6 +313,21 @@ static int m25p_remove(struct spi_device *spi)
- 	return mtd_device_unregister(&flash->spi_nor.mtd);
- }
- 
-+static void m25p_shutdown(struct spi_device *spi)
-+{
-+	struct m25p	*flash = spi_get_drvdata(spi);
-+
-+	if ((&flash->spi_nor)->addr_width > 3) {
-+		printk(KERN_INFO "m25p80: exit 4-byte address mode\n");
-+		flash->command[0] = SPINOR_OP_EX4B;  // exit 4-byte address mode: 0xe9
-+		spi_write(flash->spi, flash->command, 1);
-+		flash->command[0] = 0x66;  // enable reset
-+		spi_write(flash->spi, flash->command, 1);
-+		flash->command[0] = 0x99;  // reset
-+		spi_write(flash->spi, flash->command, 1);
-+	}
-+}
-+
- /*
-  * Do NOT add to this array without reading the following:
-  *
-@@ -387,6 +402,7 @@ static struct spi_driver m25p80_driver = {
- 	.id_table	= m25p_ids,
- 	.probe	= m25p_probe,
- 	.remove	= m25p_remove,
-+	.shutdown = m25p_shutdown,
- 
- 	/* REVISIT: many of these chips have deep power-down modes, which
- 	 * should clearly be entered on suspend() to minimize power use.