immortalwrt/target/linux/mediatek/dts/mt7981b-livinet-zr-3020.dtsi
Tianling Shen fd1bf51885
mediatek: fix wifi mac for livinet zr-3020
Signed-off-by: Tianling Shen <cnsztl@immortalwrt.org>
2023-07-01 15:38:40 +08:00

316 lines
4.9 KiB
Plaintext

// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/*
* Copyright (C) 2023 Tianling Shen <cnsztl@immortalwrt.org>
*/
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "mt7981.dtsi"
/ {
aliases {
led-boot = &boot_led;
led-failsafe = &boot_led;
led-running = &running_led;
led-upgrade = &upgrade_led;
serial0 = &uart0;
};
chosen {
stdout-path = "serial0:115200n8";
};
memory {
reg = <0 0x40000000 0 0x10000000>;
};
gpio-keys {
compatible = "gpio-keys";
button-reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&pio 1 GPIO_ACTIVE_LOW>;
};
button-wps {
label = "wps";
linux,code = <KEY_WPS_BUTTON>;
gpios = <&pio 0 GPIO_ACTIVE_LOW>;
};
};
gpio-leds {
compatible = "gpio-leds";
led-0 {
label = "red:d8";
gpios = <&pio 6 GPIO_ACTIVE_LOW>;
};
led-1 {
label = "blue:internet";
gpios = <&pio 7 GPIO_ACTIVE_LOW>;
};
running_led: led-2 {
label = "blue:running";
gpios = <&pio 9 GPIO_ACTIVE_LOW>;
};
upgrade_led: led-3 {
label = "green:upgrade";
gpios = <&pio 10 GPIO_ACTIVE_LOW>;
};
boot_led: led-4 {
label = "red:boot";
gpios = <&pio 11 GPIO_ACTIVE_LOW>;
};
led-6 {
label = "blue:d7";
gpios = <&pio 12 GPIO_ACTIVE_LOW>;
};
led-7 {
label = "blue:wlan2g";
gpios = <&pio 34 GPIO_ACTIVE_LOW>;
};
led-8 {
label = "blue:wlan5g";
gpios = <&pio 35 GPIO_ACTIVE_LOW>;
};
};
};
&eth {
status = "okay";
gmac0: mac@0 {
compatible = "mediatek,eth-mac";
reg = <0>;
phy-mode = "2500base-x";
nvmem-cells = <&macaddr_config_50707>;
nvmem-cell-names = "mac-address-ascii";
fixed-link {
speed = <2500>;
full-duplex;
pause;
};
};
};
&mdio_bus {
switch: switch@0 {
compatible = "mediatek,mt7531";
reg = <31>;
reset-gpios = <&pio 39 GPIO_ACTIVE_HIGH>;
interrupt-controller;
#interrupt-cells = <1>;
interrupt-parent = <&pio>;
interrupts = <38 IRQ_TYPE_LEVEL_HIGH>;
};
};
&spi0 {
pinctrl-names = "default";
pinctrl-0 = <&spi0_flash_pins>;
status = "okay";
spi_nand: flash@0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "spi-nand";
reg = <0>;
spi-max-frequency = <52000000>;
spi-tx-buswidth = <4>;
spi-rx-buswidth = <4>;
mediatek,nmbm;
mediatek,bmt-max-ratio = <1>;
mediatek,bmt-max-reserved-blocks = <64>;
partitions: partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
partition@0 {
label = "BL2";
reg = <0x00000 0x100000>;
read-only;
};
partition@100000 {
label = "u-boot-env";
reg = <0x100000 0x80000>;
};
factory: partition@180000 {
label = "Factory";
reg = <0x180000 0x200000>;
};
partition@380000 {
label = "FIP";
reg = <0x380000 0x200000>;
};
partition@6580000 {
label = "zrsave";
reg = <0x6580000 0x100000>;
};
partition@6680000 {
label = "config2";
reg = <0x6680000 0x100000>;
read-only;
compatible = "nvmem-cells";
#address-cells = <1>;
#size-cells = <1>;
macaddr_config_50707: macaddr@50707 {
reg = <0x50707 0x11>;
};
macaddr_config_50787: macaddr@50787 {
reg = <0x50787 0x11>;
};
};
};
};
};
&switch {
ports {
#address-cells = <1>;
#size-cells = <0>;
port@0 {
reg = <0>;
label = "wan";
nvmem-cells = <&macaddr_config_50787>;
nvmem-cell-names = "mac-address-ascii";
};
port@2 {
reg = <2>;
label = "lan1";
};
port@3 {
reg = <3>;
label = "lan2";
};
port@4 {
reg = <4>;
label = "lan3";
};
port@6 {
reg = <6>;
ethernet = <&gmac0>;
phy-mode = "2500base-x";
fixed-link {
speed = <2500>;
full-duplex;
pause;
};
};
};
};
&pio {
i2c_pins: i2c-pins-g0 {
mux {
function = "i2c";
groups = "i2c0_0";
};
};
pcm_pins: pcm-pins-g0 {
mux {
function = "pcm";
groups = "pcm";
};
};
pwm0_pin: pwm0-pin-g0 {
mux {
function = "pwm";
groups = "pwm0_0";
};
};
pwm1_pin: pwm1-pin-g0 {
mux {
function = "pwm";
groups = "pwm1_0";
};
};
pwm2_pin: pwm2-pin {
mux {
function = "pwm";
groups = "pwm2";
};
};
spi0_flash_pins: spi0-pins {
mux {
function = "spi";
groups = "spi0", "spi0_wp_hold";
};
conf-pu {
pins = "SPI0_CS", "SPI0_HOLD", "SPI0_WP";
drive-strength = <MTK_DRIVE_8mA>;
bias-pull-up = <MTK_PUPD_SET_R1R0_11>;
};
conf-pd {
pins = "SPI0_CLK", "SPI0_MOSI", "SPI0_MISO";
drive-strength = <MTK_DRIVE_8mA>;
bias-pull-down = <MTK_PUPD_SET_R1R0_11>;
};
};
uart1_pins: uart1-pins-g1 {
mux {
function = "uart";
groups = "uart1_1";
};
};
uart2_pins: uart2-pins-g1 {
mux {
function = "uart";
groups = "uart2_1";
};
};
};
&uart0 {
status = "okay";
};
&watchdog {
status = "okay";
};
&wifi {
status = "okay";
mediatek,mtd-eeprom = <&factory 0x0>;
};