From c166cb96615d8a74e91d0de40da01ffa10a89c27 Mon Sep 17 00:00:00 2001 From: Yang Xiwen Date: Thu, 10 Apr 2025 19:09:42 +0800 Subject: [PATCH] qualcommax: eap623od-hd-v1: fix phy node and LED config The reason phy fails to probe without explicitly overrided phy id is that the reset timing fails to match. Fix it with proper `reset-delay-us` and `reset-post-delay-us`. While at it, change LED settings to match EAP610-Outdoor. Signed-off-by: Yang Xiwen Link: https://github.com/openwrt/openwrt/pull/18450 Signed-off-by: Robert Marko --- .../boot/dts/qcom/ipq6018-eap623od-hd-v1.dts | 23 +++++++++---------- 1 file changed, 11 insertions(+), 12 deletions(-) diff --git a/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq6018-eap623od-hd-v1.dts b/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq6018-eap623od-hd-v1.dts index a4e49c9d6f..f54593a08b 100644 --- a/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq6018-eap623od-hd-v1.dts +++ b/target/linux/qualcommax/files/arch/arm64/boot/dts/qcom/ipq6018-eap623od-hd-v1.dts @@ -16,10 +16,10 @@ aliases { serial0 = &blsp1_uart3; - led-boot = &led_system; - led-failsafe = &led_system; - led-running = &led_system; - led-upgrade = &led_system; + led-boot = &led_sys_green; + led-failsafe = &led_sys_yellow; + led-running = &led_sys_green; + led-upgrade = &led_sys_yellow; }; chosen { @@ -40,15 +40,15 @@ leds { compatible = "gpio-leds"; - led_system: system { + led_sys_green: led-0 { color = ; function = LED_FUNCTION_STATUS; gpios = <&tlmm 37 GPIO_ACTIVE_HIGH>; }; - wlan { + led_sys_yellow: led-1 { color = ; - function = LED_FUNCTION_WLAN; + function = LED_FUNCTION_STATUS; gpios = <&tlmm 32 GPIO_ACTIVE_HIGH>; }; }; @@ -86,15 +86,14 @@ &mdio { status = "okay"; - pinctrl-0 = <&mdio_pins>; + reset-gpios = <&tlmm 77 GPIO_ACTIVE_LOW>; + reset-delay-us = <10000>; + reset-post-delay-us = <50000>; + pinctrl-0 = <&mdio_pins>, <&phy_pins>; pinctrl-names = "default"; rtl8211f: ethernet-phy@4 { - compatible = "ethernet-phy-id001c.c916"; reg = <4>; - reset-gpios = <&tlmm 77 GPIO_ACTIVE_LOW>; - pinctrl-0 = <&phy_pins>; - pinctrl-names = "default"; realtek,clkout-disable; realtek,aldps-enable;